H2D Feet No more wobble

No more WOBBLE !!!

 

I wasn’t a fan of the wobbly H2D feets, so I designed my own version. This model has been tested and prints flawlessly in TPU 95A on the Bambu H2D. 

You need to take the original screws that are on the feets, remove the screw and the washer from the feets and then put it in the new TPU printed parts. You will need a flat screw driver to remove the original rubber feets as they are glued a bit in place but its not hard to take out.

Here is the link to replace the feets with bambu instructions :) https://wiki.bambulab.com/en/h2/maintenance/replace-anti-vibration-feet

Enjoy :) 

Boost MeA boost means a lot to me