Big Brick Brick Costume Full fig 500%

Show your love for the brick with this Brick costume fig! A big version of the classic minifig that prints without AMS or supports and is fun to assemble! And it's the full figure!

UPDATE! New female version now available!

To assemble

Start with the hips. Slide the cross pin into the bottom, it will be snug! Then insert the lock into the top of the hips to hold them in place.

Next take the waist connector nub and insert it into the the square in the top of the hips, then slide outward making sure to pay attention to the lip as it goes to the outside as shown. Then repeat for the other nub and use the square plate to lock everything in place.

Next grab the torso and front and back plates. Place the front and back plates over the dovetails on the torso aligning the square holes to the pins, then slide them down into place. If they're a bit loose you can add a dab of glue to hold them solid. Then insert the arms and hands.

Slide the eyes and mouth together as shown.

Female head assembles the same.

And the slide the face inserts down at an angle.

The hair uses the ring to twist both halves together. Make sure to pay attention to the alignment of the top and bottom of the hair.

Female hair assembles the same.

Press the legs onto the hips being sure to press straight to avoid breaking the hips.