[hueforge]绝区零Zenless Zone Zero 薇薇安 Vivian Banshee

建议0.2的配置

Project: 薇薇安 get.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 132.56x200mm in size
You may print at higher layer heights below the Min Depth of 0.24mm
The Max Depth is 2mm and the Actual Depth is 2mm

Filaments Used:
    PLA BambuLab Basic Black Transmission Distance: 0.6
    PLA BambuLab Basic Red Transmission Distance: 4
    PLA BambuLab Basic Yellow Transmission Distance: 6
    PLA BambuLab Basic Blue Transmission Distance: 4
    PLA BambuLab Tough Lavender Blue Transmission Distance: 2
    PLA Protopasta White Transmission Distance: 3
This print uses 6 unique filaments

Swap Instructions:
    Start with Black
    At layer #3 (0.32mm) swap to Red
    At layer #7 (0.64mm) swap to Yellow
    At layer #12 (1.04mm) swap to Black
    At layer #13 (1.12mm) swap to Blue
    At layer #18 (1.52mm) swap to Lavender Blue
    At layer #19 (1.6mm) swap to White for the rest.
 

-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

Project: 薇薇安 黑白灰蓝.hfp

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm

The Model is 132.56x200mm in size

You may print at higher layer heights below the Min Depth of 0.2mm

The Max Depth is 2mm and the Actual Depth is 2mm

Filaments Used:

PLA BambuLab Basic Black Transmission Distance: 0.6

PLA BambuLab Basic Blue Transmission Distance: 4

PLA BambuLab Basic Gray Transmission Distance: 2

PLA Protopasta White Transmission Distance: 3

This print uses 4 unique filaments

Swap Instructions:

Start with Black

At layer #6 (0.6mm) swap to Blue

At layer #11 (1mm) swap to Gray

At layer #18 (1.56mm) swap to White for the rest.

-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

Project: 薇薇安 黑白灰.hfp

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm

The Model is 132.56x200mm in size

You may print at higher layer heights below the Min Depth of 0.2mm

The Max Depth is 2mm and the Actual Depth is 2mm

Filaments Used:

PLA BambuLab Basic Black Transmission Distance: 0.6

PLA BambuLab Basic Gray Transmission Distance: 2

PLA Protopasta White Transmission Distance: 3

This print uses 3 unique filaments

Swap Instructions:

Start with Black

At layer #6 (0.6mm) swap to Gray

At layer #18 (1.56mm) swap to White for the rest.

图片实体是 黑 白 灰 蓝 四色的效果