Cr touch replacement housing/cover FDM Optimised

Remix of the original optimised for minimal (or no( support (i.e. for FDM printing). 

The base which gets screwed to the mount is 2mm thick that is thicker than the original so the Z offset will need to be adjusted (increased) after install. 

Printing

I printed this in ASA so it can withstand any heat from the build plate but PETG works too.

I recommend using a 0.2 nozzle (but 0.4 works too) and as low layer height as possible. I used 0.08 on my Ender3v2 with Sprite extruder, on which it this fits perfectly.