Worlds Smallest Benchy | Only 0.52g | 0.4MM Nozzle

 

Boost Me🚀 Think this is the smallest Benchy ever printed on a 0.4 mm nozzle?
Please consider dropping a ⭐ boost if you agree!
Every bit of support helps launch this tiny tugboat into more hands across MakerWorld! 🛶✨🧵

🛶 The World’s Smallest Benchy – 0.52g, No Brim, 0.4mm Nozzle

Here’s my take on the smallest Benchy you can print with a 0.4 mm nozzle. No mods, no fancy tricks — just regular PLA and some careful tuning.

It weighs only 0.52 grams, prints in about 17 minutes, and still has all the classic Benchy details. Printed at 0.08 mm layer height, with no brim and no supports. Honestly surprised it worked this well.

This might be the absolute limit for a functional Benchy on a stock 0.4 mm setup.

🧪 Print Settings:

• Filament Used: ~0.52g (less than a gummy bear!)
• Layer Height: 0.08 mm
• Nozzle: 0.4 mm
• Supports: Nope
• Brim: Not needed
• Print Time: ~17 minutes
• Material: PLA (I used Bambu Lab Orange)

🧵 Extra Notes:

A great micro-print to flex your tuning skills, show off your calibration, or just make people go: “Wait… it actually printed that?!”
Ran this on a well-tuned profile. If your cooling and first layer are dialed in, it should work fine — just don’t sneeze near it.



If you enjoyed the print, consider leaving a like and a comment! It really helps boost its visibility. Thanks a ton, and may your prints always turn out flawless!

Join my discord: https://discord.gg/5aYcbSX37K 

(Physical Prints only not the actual 3MF Model) Want permission to sell my model? DM Me on discord or any of my socials and I'll say yes:) Always.

Patreon: https://www.patreon.com/c/3DOdyssey (Not too many benefits from signing up :( You just basically support my work which means a LOT to me :)