Schrader to 4mm adapter

I designed and released the original adapter to enable the careful recharging of aerosol cans with a compressor.  I had some feedback requesting a version to work with a tyre compressor. This remix basically has a schrader thread replacing the piece that used to fit over the compressor nozzle.  I'm not convinced a tyre compressor will be able to provide the burst of power required to start the process.  Didn't work with my little tyre compressor but you may have more luck. As per the original model. please be very careful if attempting to repressurise a can as the contents may spray out and if you go too far the can may well explode.   TAKE CARE

I printed it standing up so the thread will not be super-strong however was good enough to screw into a tyre inflator snugly. You may need a brim if you print more than one at a time or if your print bed is not too good.

0.5g of filament and about 5 mins printing time. 

If you have a compressor, the original is a far better option for you.