Micro Cache - Keychain Cash Holder

Use this to store cash (bills) on your keychain for use in emergencies.

[Warning: it should be periodically checked for tightness: I have used mine for months and (once so far) found it had loosened slightly open in my pocket. It is just a thread that holds it together against all the random forces in your pocket/purse, and just like headphone cables, crazy stuff happens!]

 

I designed this to fit on your keychain using the Bambu Makerworld keyring. It is very strong at the keyring hole, prints fast, and uses a bit less than 10g of filament. It also is sized to fit at least all bills between: USA, Canada, EURO, Australia, and China. But you have to fold them a certain way, see below.

 

Internal dimensions of the container (eg, what you can store) are: 43.5mm tall and 10mm in diameter for the entire two-piece cylinder.

 

1. I did not test the waterproofing of this design, and it was not designed to be waterproof. If you use it for pills or anything that really shouldn't get wet, please use caution or go with another design. Please let me know if you want me to upload a design for an o-ring to fit into a recess or something like that. I don't currently have o-rings to test it with.
2. The threads are always a bit tight on the initial printed model. Just tighten/loosen the two pieces together a few times and they slowly come together. 
   1. I tested it with Bambu PLA Basic, Bambu PLA Matte, Bambu PETG-HF , Generic PETG-High Speed , and Bambu PETG Translucent. The only one that failed to thread correctly was the Bambu PETG Translucent using the default print profile for that material. I did not feel the need to calibrate it, and just stopped testing there. The other materials worked consistently.

Boost MeBoosts help buy more filament for testing new designs! And it makes this amazing hobby feel that much more rewarding to see that people enjoy what you make.

Instructions for folding your bill are as follows:

 

 

 

 

Then, just roll it across and try to ensure it isn't very square on either end. You want it rolled into a cylinder-like shape to then pop into the Micro Cache

 

Also Note: I marked it as non-commercial so please get in touch with me if you would like to sell it.