Gift box (No AMS required)

I used this gift box for giving away a baptism gift for my friend.

 

The inside volume of the default box is approximately ~ 120x150x60mm but is of course scalable.

 

Generic PLA setting should work fine at 0.2m layer height. The only change I did to default settings was changing to gyroid infill.

The print will require some cleaning of support material, but it's manageable. 

It should snap together just fine, if not-, applying some glue is suggested.

 

Friendly reminder to tick automatic support (normal) for the files that require this!

 

Suggestions/changes is always welcome

 

Boost MeBoosting is always appreciated, never expected. It works as a good motivation for me to keep sharing my files as I mostly print stuff for personal needs.

Thanks in advance!
Best regards
David