Sovol SH01 Dryer Vent

This simple vent allows moisture to escape while actively drying for the Sovol SH01 (Should also fit the Comgrow dryer of the same design but do not own one to test).

 

The vent ensures moisture has an exit point without letting all the heat out. I find I get consistently lower humidity readings since using this as apposed to just leaving the lid open on the clips. The temperature is also consistent with what I set it to when using.

 

The clips on the front allow the filiment to be used while drying without the lid being pulled completely open.

 

Recommended to print using PETG to prevent softening or warping. I have printed with eSun black PETG and has worked flawlessly.

 

Please ensure your build plate is clean as these parts have fairly small contact area with the build plate. With a clean plate printing without brim is ok.

Boost MePlease share if you think others would find this useful