Jolt Water Pistol fully printed A1 mini 15m range!

3D printed water pistol, no external parts or seals required, prints in 2 hours!

UPDATED: NEW MAGAZINE FOR 5x AS MANY SHOTS:

https://makerworld.com/en/models/1422306-jolt-water-pistol-upgrade-multi-shot-magazine#profileId-1477836

 

print on one plate on the a1 mini or any other printer in PLA, auto tree supports are removed easily. To assemble:

-slide the barrel into the main pistol body

-slide the refill cap on sideways over the dove tail joints

 

2 ways to re fill:

-slide of the dove tail jointed cap and fill with water before sliding back on the cap

-fully slide out the barrel, cover then end with your finger and fill up with water through the large hole in the rear, before sliding the barrel back in

 

The furthest I have got it to shoot is 22m, 15 is regularly achievable to give you maximum range in your water fights! 

 

note: due to this design being quick and cheap to print, and therefore having no rubber seals, a smal amount of water can leak out of the back of the pistol when in use. A tighter tolerance barrel has been tested but increase friction to much. Putting vasaline over the barrel is another option, but if your having a water fight your going to get wet anyway!

 

Boost MeWhen I showed my brother the first thing he said was "That's so cool"