Bose QC25 liner w cushion tabs

Remix from Ludos model, since the tabs on my headphones are falling off. 

Note, you need to trim off any remaining traces of the tabs/rim that the tab was attached to, this can take some effort. I only did one side as the other was still strong! There i only replaced the liner, to get a symetric look, so i also added a tabless ring - this one is a tad thinner than the original model, giving more space for the hinge.

Note on material - I first printed in PETG on Ludos design. was super tight, but possible to get on because of flexible material. But this also broke on removal. When i was done with this remix, i had PLA on the roll, so i gave it a shot - perfect result! But i think this one is a tad bit larger, so perhaps fine for PLA but PETG might need a tighter fit.

Good luck!