Escape From Tarkov Figurines | Chibi / Funko Pop

Note: Missing the Cultist & Labyrinth characters [5/16/25].

Note II: Print profile optimized for strong but quality models with a 0.4mm nozzle.

Note III: Models can stand alone or slide into their standing pad.

 

Warning: The characters, at their current height, require high precision calibration. A smaller nozzle is recommended [0.2mm].

Warning II: Again, at their current height, bed slingers will have a hard time with the weapons and small details.

Warning III: If you DO NOT increase their size, you need to be careful when removing supports. And even then, be careful.

 

Known issues:

1. Bear: Hip holster holding on by a thread. Headset lifted off head leading to print errors/breakage.
2. Bear 2: Shotgun shell in hand holding on by a thread.
3. Scav: AK tip very thin and prone to failure/breakage.
4. Scav 3: Satchel likely to be snipped during support removal.
5. All: Weapons are too thin at certain points.

I will revisit these to improve the known issues. 

 

Support me by listening to my music: https://spoti.fi/3Yg7XoH

Boost MeAre you happy with your print? Would you like more models like this one? Boost your favorite designs, so I know what to make.MembershipDrop a monthly donation to fund new designs OR unlock full access & exclusive rights to sell, edit, & remix my models by becoming a member!