Corne 4.1 Angled Bottomplate

Angled corne 4.1 bottom plate.

• Angle is about 3 degrees.
• Recessed areas for silicone feet (8mm).
• Screws for board mounts are inset to allow for the same m2 screws that are part of the build guide on github.
• Print is shown above with the silicone feet because I assembled before taking photos. I included a render though to show the recesses for the feet.
   

Printed at extra fine or 0.08mm layer height to minimize angle steps on final print. I meant to print on the smooth plate, but forgot to swap it out. I would recommend the smooth plate over the textured plate to ensure that the standoffs are mounted flush. In my print, this ended up not being a problem.