AMS REPLICA FOR BMCU

Boost MeA BOOST TO THE MODEL WOULD BE APPRECIATED SO AS TO HAVE FEEDBACK AND HAVE SUPPORT FOR FUTURE UPDATES, MODS AND ADDITIONS FOR THE AMS LITE BMCU,
THANKS SO MUCH <3

AMS LITE REPLICA FOR BMCU

After extensive design and testing, the  AMS Lite replica for bmcu  is finally here!

UPDATE!!

I FINALLY UPLOADED THE PRINTABLE MODEL WITH BAMBULAB A1 MINI WITH THE DEDICATED PRINTING PROFILE, MAKE SURE TO SELECT THE CORRECT PROFILE FOR YOUR PRINTER DURING THE DOWNLOAD

Features:
-Compact spool holder for bmcu 370x
-Only few parts needed for assembly
-Compatible with original ams spool rotary

I found on makerworld a project for a spool holder compatible with the original ams that was right for me, you have to print a pair of green spool holders, and a pair of orange spool holders, below I leave the link to the reference model:
https://makerworld.com/en/models/424607-alternative-rotary-spool-holder-for-ams-lite-liao#profileId-328034

materials list:
-N° 8 ptfe tube connector
-N°14 3x16 self-tapping wood screws ( N°18 3x16 self-tapping wood screws for a1 mini version)
-N° 2 2.5x20 self-tapping wood screws

-N° 4 ptfe tubes 130mm/(13cm) long

Instructions:

1. Print all the model in the file and all the rotary spool holder

2. Take the upper ams, and lower ams parts and n°6 3x16 self-tapping wood screws
    

   
    

3. fit the 2 components together and fix them with the 6 3x16 screws in the side holes as in the picture
   N.B. please make sure that the orientation of the two pieces is as in the photo, the slots in the pins for the spool holders must be one square and one hexagonal on the same side

   
    

4. take the ams stand and n°4 3x16 self-tapping wood screws and assemble it with the previously assembled part
   N.B. make sure that the orientation of the previously assembled ams upper structure is as follows:
   looking at the ams from the front, the hexagonal joint must be in the upper right part and the square joint must be in the upper left part (as in the original ams)
   N.B.  For the ams stand for bambulab a1 mini assemble the upper stand and the lower stand with n°4 3x16 self-tapping wood screws, the assembled result must be the same as the stand shown in the photo
    

   
    

5. take the bmcu support and screw n°8 connectors for the ptfe tube in the 4 holes, 4 in the upper part and 4 in the lower part
    

   
    

6. Screw the BMCU to the BMCU support with n°2 2.5x20 self-tapping wood screws using the holes provided on the support and on the BMCU
    

   
    

7. size n°4pcs of ptfe tube long 130mm/(13cm)
    

   
    

8. install the 4 ptfe tubes in the respective connectors between the support and the bmcu
    

   
    

9. Install the bmcu-support block on the previously assembled ams structure with n°4 3x16 self-tapping wood screws
    

   
    

10. install the 4 spool holders as described in the guide in the link to the model that I left you previously
    
    
     

11. Install the filament spools with the following orientation
     

    
     

12. connect the bmcu to the printer and have fun with your new ams!!