Sanding Wedge V2

Printables Link

General information

As you might have guessed from the title, this is the 2nd version of my sanding wedge. I made the models in Autodesk Inventor.

The new design is Fully 3d printed, no bolts or nuts needed.

Technical details

This sanding wedge is made for 50mm wide sandpaper. The sandpaper must be at least 310mm long for the original version and 225mm for the small version.

I recommend you buy a roll of Sandpaper that already has the desired width and then cut it to length.

Here are some I found on Amazon:

• Bosch DIY Sanding Roll for Metal 50mm 5m 120 Grit
• Klingspor 4224 - KL 361 JF Sanding Rolls with Fabric Backing, Brown, 50 x 25000, Packaging Unit 1 - Grain 180

Update 11.10.2023 : I added a brim and spread it over more plates to reduce printing errors. Also made the hole in the "wedge" bigger because it was too tight.