F1 Mini Brick Car Full Grid Wall Holder

I wanted to hang my collectible F1 Mini Brick cars (Cough cough LcoughEGO) on my wall, and be able to keep them in order of the constructors cup. I tried to keep it very simple, and printable on a wide variety of printers and setups.

 

I use the same hook system as my single holder, but now even better fitting, to hang the cars by the front wings. Zero supports, and the starting box lines are printed on top of the model, so you can print it without AMS by doing a layer pause and filament change before the last layer.

 

Print is done by object to save from printing a prime tower and a bajillion layer change poops.

 

I printed mine out of PETG, just my filament of choice, and the tolerances are done with that in mind. You MAY need to trim the connecting pieces a tiny bit, or glue them together. Mine has zero glue or trimming needed, but obviously your printer will be different and your mileage may vary!

 

With my dry PETG, the three plates snapped together perfectly and firmly, and I hung it on the wall with two small nails only. You could also use command or double side strips on the back if you wanted. 

 

If you're interested in a single holder, I have another print for that here: https://makerworld.com/en/models/1438396-mini-f1-brick-car-display-stand#profileId-1496701 

 

Boost MeHelp me create more! Show your appreciation with a boost. Only George Russell fans don't boost.