Hanging Plant Pot, Plant Hanger

Wife wanted a hanger designed for some small leafed/succulent plants that took small pots. There are three models to print (if you need all three). First the plant holder which is in two parts but on the same bed, it has modifiers added to parts that need to be a bit stronger. Then the pot and lastly the plant pot with small drainage holes. The last pot may not be need if you already have, or can get, the small pots which are readily available as these will fit, although for the small price I personally would print your own.

When connecting the plant holder together it needs to be pushed in one side first and then the outer ring will give/flex to fix the opposite side as shown in image below.

Even if you pay full price for your filament it’s a very cheap print to make.

 

 

 

 

 

0.20mm layer height

5% infill (Honeycomb)

2 wall loops

 

please leave any comments below thank you.

 

enjoy.

 

Boost MePlease consider leaving me a Boost if you find this print useful, it helps to judge what type of models are required... thanks