Molecular Model_fullerene

<Product Description>
・This product is a molecular model.

・Product size (w×d×h）：120mm × 114mm × 116mm

・This product consists of 60 spheres and 90 rods.

・If it is difficult to print all parts, print a smaller quantity multiple times.

・The spherical object data is floated slightly with a cube object in the 3mf and STL data to make the bottom finish as clean as possible.

・The sphere has three holes, which are used as shown in the following image.

 

 

<Production＞
・This product was created using Blender.
・Output was done using BambuLab A1 mini.
 

<Notes> 
・Please use this product as an object. Please refrain from using it for any other purpose.
・Please be careful when handling this product, as it has a sharp tip. Especially, please keep out of reach of children.
・Please note that we will not be responsible for any accidents or injuries caused by this product.

・We will not be responsible for any damage to a table, etc. caused by the use of this product.
・The photo is for illustrative purposes only.

・When importing into the slicer software, You get the message “Do you want to repair the model? If the model cannot be successfully printed after repairing the model, print the model without repairing it.
・Please note that the product is still in its infancy as a product designer, and that there may be imperfections.
・Please print and use this product only if you agree to the above precautions.

 

We would be very grateful if you could send us your comments and evaluations, which will encourage us to create this product.
Thank you very much.

 

Boost MeMembership