Switch 2 wall mount with built in cable organizer

Switch 2 wall mount with built in cable organizer

This print will allow you to mount your Switch 2 dock to the wall. It features a vent at the bottom and back to allow for maximum airflow, very little restriction thanks to the fully open vents at the bottom with no grille over key components. On the bottom of the mount you will find a hole that will allow cables to be fed through to the right side for a hidden and clean installation.

Key features!

• Built in cable organizer!
• Ample space for intake and exhaust.
• Screw holes with 100% infill backing for extra strength!
• Super easy print with very little support
• only 65g of filament!
• prints in just over 2 hours!

Tips!

Install it with 2 screws with suitable hardware for your wall, the hole allows for up to 10mm in head size. Then feed the HDMI cable up through the bottom hole and follow up with the USB-C power cable and plug them into your dock. Place the dock into the holder making sure it sits down all the way, the fit should be slightly snug. Lastly gently pull the cables underneath to make them totally hidden from the side!

Notice!

Mounting this with incorrect hardware may cause the entire bracket and console to fall off the wall, make sure to ask a professional if you're unsure of what mounting hardware is needed.