Ikea Skadis Wire Spool Holder

Looking around at the other wire spool holders out there, I wasn't terribly satisfied. All seemed to use a bit more filament, had finicky printing (supports, post processing), or just wouldn't hold the number of spools I had.

So I made this one. It holds 6 spools, has feed-holes in the bottom front, and supports holding 6 spools up to 60mm in diameter.

Since this uses the Skadis T-Nut system, you will need the following hardware:

• 2xM2.5x10 Bolts
• 2xM2.5 Nuts

I've added these to the BOM below, so if you don't have any on hand you can purchase some from Bambu Labs