wine bottle holder

Box for a bottle of wine. 

Adding some magnets makes it open in a special way. See animated gif.

several sets of magnets.

1. holding each layer together.  34 magnets
    

2. near pivot help the layers open. 34 magnets
    

3. holds latch closed. 4 magnets
    

If functions without all the magnets. But it adds some interesting movement.

two sets of parts 1 thru 9  

and one of part 10  (the layer with the latches).

The pivot (that you can't see) is inside the layer print, is a little weak. Don't use too much force to open.

Each layer needs to be glued to the layer next to it. There are conical index pins to align them. I used one drop of glue on each cone. Then clamped them together the stack. Make sure the glue does not glue the sides. When you clamp it, make sure the stack is strait till the glue is fully dried.

the stack is

1

2

3

4

5

6

7

8

9

10

9

8

7

6

5

4

3

2

1

The latches are not strong enough to just grab the latches and open.  Open the latches, then grab the pieces the latches are mounted in and open. You might need to open the end parts.