Helldivers 2 - P-92 Warrant Gyrojet Pistol

This is a model of the P-92 Warrant , a specialized gyro-jet pistol designed for law enforcement officers in the universe of Helldivers 2.

 

The weapon is inspired by the Robocop's Auto 9 pistol and the Lawgiver from the Judge Dredd universe.

 

This model has a trigger that works with a small spring and a magazine that works with friction , it you can also glue the sight in both positions , the guided and no guided one , it includes a couple of bullets , they don't look like gyro-jet to me but they are very similar to the ones in game.

 

This model is A1 mini compatible and AMS is not required for the pistol , only for the bullets and even then you can just print them in one color.

 

I made this model in record time so i hope you enjoy it , if you want some other models of weapons in video-games leave in the comments , im also designing a stand for this replica that i will post in the future. 

 

----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

 

I also made a stand for this model you can find it here

 

 

Boost MeBoost are apreciated!!!

 

For assembly:

 

First of all the things you are going to need:

• A fast glue with acelerant preferably , some normal glue with some tweezers or a lot of patience can work too.
• x1 Spring 17mmx5,5mm (Another spring from a pen can work for this too)
• Some string from filament to make tiny cuts out of it.

This model uses bits of 1,75mm filament to use as guides like in the image:

 

Lest start with the most tricky part , the trigger , if you want you can just glue together this two parts , if not you have to put the spring in the red part. 

 

This is were the acelerant will come handy , you have to insert the 3 parts into the trigger guard , since the spring is going to be under pressure is going to want to come out so you have to be careful with that , is better to put a little glue on the right side of the contraction.

 

Now we can add the grip using the two guides.

We can also add the slide into the top part.

 

Now is the time to add the sight we can glue it in two ways , into the guided shots position or in the iron sights positions , the scond one can be a little tight so you might have to sand it a bit.

 

 

Now we can go to the second block of parts , we will take the upper receiver , we are going to glue the barrel and the bolt , they should just slide in , you dont need a lot of glue for this part.

 

 

In this part we can add the lower receiver and with the help of the guides , also both of the skulls , you only need a tiny amount of glue for them.

 

 

Now we will glue the to part together , is important that this union is solid so you need to glue all the parts that are going to be in contact not only were the guides are , this include the part of the bolt that goes into the slide.

The last part is going to be the mag , you are going to need to sand the part into the red circle until it slides on and off , its hard to compensate for different tolerances in different machines so its better to put a bit to much that can always be sand down than too little.

 

 

 

This is optional but you can also glue 2 of the bullets to the magazine like in the picture below.