Updated on 14 Nov 2025: I noticed some users printed the model with Supports turned on despite the instructions, likely because the description was overlooked. I’ve updated the cover photo to highlight this more clearly.
----------------------
Updated on 6 Nov 2025: A similar model for iPhone charging only can be found here (https://makerworld.com/en/models/1963947-iphone-charging-stand-magsafe-gen-2#profileId-2111328).
----------------------
This charging stand is designed to be both a functional gadget and a stylish addition to your workspace.
Please take note of the followings before downloading or printing:
- Print Time: The full print takes approximately 5.8 hours, even at a 0.28mm layer height.
- Print without Support: The model is designed for printing without Supports, as configured in the included print profile. If you use custom print settings, ensure that the Support option is disabled. You can safely ignore the warning message prompted by the slicer.
- Landscape Mode Only: Because of the design’s geometry, it can only support iPhone mounted in the landscape orientation.
- Charger Compatibility: Designed specifically for the MagSafe Charger (Gen 2). The slot measures 55.9mm in diameter and 4.5mm deep.
- Connector Type: The rear opening is designed to fit only cables with USB-C connector; cables with USB-A connector are not supported.
- Stability & Counterweight: A counterweight is essential for stability when supporting an iPhone. A built-in compartment with a screw cap allows you to add your choice of counterweight material—such as coins, sand, plaster or clay.
I hope you enjoy using this stand as much as I enjoyed designing it!
rustichands
