FC Barcelona

AMS required

height with base 16,6cm

width 14,8cm

The model requires glue for assembly (e.g. superglue).

Since the FC Barcelona logo consists of 7 colors, I have published two profiles:

• The first profile is for printers equipped with two AMS units.
  Each side of the logo is printed as a single piece. This version simplifies the assembly process (you can skip the first two steps of the assembly instructions).

   

• The second profile is for printers equipped with one AMS unit.
  Each side of the logo is printed in two separate parts that need to be glued together. This version requires more time during assembly. The first two steps of the assembly instructions must be performed twice (once for each side of the logo).

Assembly Instructions:

1. Insert the smaller part into the opening of the larger one as shown in the image (it should sit slightly recessed in the opening).

(Step 1 only for printers with one AMS) 

2. Apply a small amount of glue to the sides as shown in the image, then remove any excess. After the glue has dried, level the surface so that the inserted part does not protrude above the opening.

(Step 2only for printers with one AMS) 

3. Insert the connectors into one side of the logo, then glue both sides together.

4. Glue the logo to the base.

For printing the logo parts, I recommend using a smooth PEI plate (it will be easier to glue them if the back is smooth). The base can be printed on a textured plate.