Raspberry Pi 5 Display Fit Vented Case

This is a vented Raspberry Pi 5 case that provides access to a display through the GPIO header, as well the DSI and PCIe ribbon cables, and is compatible with the official active cooler. Keep an eye out for additional variants, including ones with side access. Supports are not necessary; however, if you plan to use the DSI slots, they shouldn't require them—but depending on your overhang settings, they may be a bit tight.

 

The display in the cover is the Waveshare 2.7inch e-Paper HAT (https://www.amazon.com/-/en/dp/B075FWLMRV)

Boost MeBoosting helps me afford my filament. I really appreciate all of your support!

Printing Guidelines:

• Material: PLA or PETG is recommended for durability and a clean finish.
• Layer Height: 0.2 mm for a good balance of speed and detail.
• Infill: 15-25% is sufficient for excellent strength.

 

This is a remix of addohm's https://makerworld.com/en/models/49252-raspberry-pi-5-snap-fit-vented-case?from=search#profileId-128513