Pony pipe clamp stands

The stands prevent Popy Jorgensen pipe clamps from falling over constantly. They also elevate the clamps slightly. 

Part A keeps the clamps upright and must be placed on the screw side. Part B is the end support and can be placed anywhere along the pipe near the sliding end. 

The stands are used with the ¾ inch (20mm) pipe clamp fixture.

Printing tips

• Take note of print orientation and support in images - prints must lay down flat on the print bed. 
• Supports: paint supports only on bottom of protrusion for Part A and use normal supports (not tree) for smoother result. Part B doesn't need supports. 
• First layer and top surface: 0.36mm
• Infill: Cubic 15%
• Printed in PETG, but PLA will also work. Watch out for too much layer cooling to prevent warping.