Graffiti Alphonse Elric Hueforge

Boost MeWith the changes to points, boosts are one of the best ways to support creators! Any support is welcome!

 

Want to sell my prints? Commercial License now available here: https://patreon.com/3ReePrinting

 

MembershipCommercial License also available here!

 

Check out the rest of my Hero/Villain series here: https://makerworld.com/@3ReePrinting/collections/3340968

 

The kids and I are watching Full Metal Alchemist and Alphonse is the favorite so far! I usually say you can substitute Glow Blue for Cyan, but for this print unfortunately I would say Glow Blue looks good and Cyan does not.

 

This print is the maximum build plate size for an A1 Mini, but it should work on any printer.

 

If you resize the model make sure you do NOT scale the Z axis or the print colors will not be in the same position

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm

The Model is 170x170mm in size
You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 2.24mm and the Actual Thickness is 2.24mm

Filaments Used:
    #000000 PLA BambuLab Basic Black  Transmission Distance: 0.6
    #c00d1e PLA BambuLab Basic Red  Transmission Distance: 4
    #ffffff PLA BambuLab Basic Jade White  Transmission Distance: 5
    #7ac0e9 PLA Bambulabs Glow Blue  Transmission Distance: 6
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #7 (0.4mm) swap to Red
    At layer #16 (0.76mm) swap to Jade White
    At layer #22 (1mm) swap to Black
    At layer #29 (1.28mm) swap to Blue
    At layer #47 (2mm) swap to Jade White for the rest.