1 in Dowel Bracket 30 Degrees

This is a model for 1 inch dowel brackets to hang folding chairs. They can also be used as a shelf for camp chairs or to hang just about anything. The dowel angle to the wall is 30 degrees. I printed it in PLA with Bambu Studios “Strength" settings. Two of them hold 60 pounds of chairs without any problems. I used 12" poplar dowels. I placed a hole so you could screw or nail the dowel from the side but there are into the bracket 1.5 inches and the fit is very tight. I don't think they will come out without a screw. I glued some of them. 

I am new to tinkercad so I didn't know how to line up the drill holes with the recessed holes for the screw heads so those are a bit off. But it works!