Two pieces of 3D printing filament 1.75 mm from the roll
Assembly instructions
Please watch the YouTube video for the assembly steps.
Rough overview of the steps:
Attach the adhesive tape holder to the case
Mount the inlay in the case
Attach the magnets to the case and door
Attach the plastic window to the door
Attach the door handle to the door
Attach the door to the case
Filament
All parts were printed using PLA material.
Colors:
red
black
white
Optional for support interface layer: PETG
Print Information
All parts are printed in 0.2 mm layer height. There are exceptions for the following parts:
The door is printed in 0.12mm layer height to improve the thread for the door handle
The threaded part of the door handle is printed in 0.08mm for a better quality
Support needed only for small areas on the tape holder mount in the case and the tape holder. You can print it with a single filament and break off the support or you can print it with a support release layer like I do. I print the parts from PLA and the support interface layer with PETG. PETG can be easily detached from PLA. This gives you a nice surface.
The tape holder was placed on the printing platform in this way for better stability. This prevents the holder from breaking on the case
Support blockers are attached to the hinges of the case so that the hinges can be printed better.
Internal Project settings for X1C available. These is the printer I used to print and test the parts.
Tinker.fun
