Flakpanzer 341 Anti aircraft Tank Panther 1:35

================================

📋 Recommended Print Settings (For Best Results) 

• Filament: PLA. Different materials have different shrink rates, so using other filaments might cause fitting issues or dimensional errors during assembly. 
• Slicer: Bambu Studio. I recommend using my default profile — I’ve tuned it specifically for this model. 
• Ambient Temperature: If you’re using an open-frame printer like the A1 or A1 Mini, keep your room above 20°C (68°F) to prevent warping. 
• Print Bed Preparation: Wash with soap and water, then dry thoroughly to ensure good adhesion. For small parts, apply a glue stick for better bed adhesion. 

🔧 Assembly Diagram Notes 

• You’ll need super glue to attach all the components together. This is an early build of mine, so all the wheels need to be glued in place.

I designed two small springs to be placed inside the turret for locking the barrel. This allows it to move while providing sufficient friction to hold it in place. I made the corresponding edits in Bambu Studio and configured the surface of the barrel that contacts the spring as a hollow mesh to increase friction.

This is the rangefinder. Please ensure it is installed in the correct position.

The Panther Medium Tank’s running gear uses a complex interleaved road-wheel mechanism, below are the installation procedures for these assemblies:

The 6 plates are the heat-dissipation mesh, I use Bambu Lab’s software to set the top shell thickness to 0, choose “Grid” for the infill pattern, and set the infill density to 50%—this will simulate the mesh effect.