Under Monitor Sticky Notes Holder // No supports

I was tired of my sticky notes falling off the monitor and ending up all over my desk, so I made this holder for 3 sticky notes that goes under the monitor. 

It’s compatible with all monitors with a maximum width of 35 mm (may not work with many curved monitors).

This design requires no supports and no glue — everything snaps into place with push-fit. 

Note: The maximum monitor width is 35 mm: I recommend measuring it before printing.

Important to know:

• 🗒️ Press-fit sticky note clips: No glue needed. The clips have a small tab that holds the sticky notes firmly in place.

• 📐 If you’re not using the provided print profile, make sure the base is positioned as shown:

   

• 🤏 Clip too tight or sticky note falling off? Simply bend or adjust it until you get the right amount of grip.

   

• 🧽 Clean the bed and use a brim: Due to the base’s orientation, it needs stronger adhesion.

I hope you enjoy this design! 

I’ll be reading all your feedback and suggestions for any tweaks or improvements.