VantaTag – NFC Tag Holder for VantaFocus App

The Story

I built VantaFocus because I was tired of my phone hijacking my attention.
The VantaTag was born as a simple, physical way to snap into focus mode without fiddling with apps or timers.
Place your phone on the tag, and distractions disappear — whether you’re working, studying, or winding down at night.

VantaTag – NFC Tag Holder (Mono & Multicolor)

This is the official NFC tag housing for VantaFocus – the productivity app that helps you block distracting apps and stay focused.
Simply place your phone near the VantaTag to instantly activate focus mode. Perfect for keeping your evenings, study sessions, or work hours distraction-free.

🔗 Learn more about VantaFocus: https://vantafocus.com


Included versions

• VantaTag Mono – for single-color printing (no AMS or filament swaps required)
• VantaTag – for multi-color printing (supports AMS, MMU, or manual filament swaps)

Printing recommendations

• Material: PLA or PETG recommended
• Layer height: 0.2 mm
• Supports: Not required
• Infill: 15–20% is enough
• Print with VantaFocus.com at the top - gives a nice finish on the front 
• ATTENTION: You have to pause the print at 2mm height to insert the NFC Tag and on 4.6mm height to insert the 3 magnets 

Parts needed

• NFC Tag Sticker (25mm round) – Amazon link (affiliate)
• 3 × Neodymium Magnets (3x6mm) – Amazon link (affiliate)

These are affiliate links – I may earn a small commission at no extra cost to you.

💡 Have ideas for improvements? Feel free to remix and share!