Mavic Air Lens Removal Tool

This is a simple tool for removing the factory Mavic Air lens so an ND or other filter can be installed. The factory lens is very difficult to remove without some mechanical advantage.

See the pictures for examples of the intended way to hold the tool in relation to the drone and proper orientation of the tool on the lens. With the drone powered off, turn it upside down and place the tool over the lens oriented as in the photos. Hold the gimble in place with your left thumb and use your thumb and two fingers from your right hand against the tool's nubs. While holding the gimble in place, gently (but firmly - it's a balance), unscrew the lens with your right hand while keeping the tool clamped evenly around the entire circumference of the lens.

Once you get the factory lens off, you won't need this tool again - there's no need to tighten the lenses down that tightly!

No support structures are needed. The examples in the photos were printed with PLA at .2mm. No infill is required, just a gap fill as the body is only 2mm thick.

Did this help get your lens off? Did it not work for you? Have improvements for the design? Your comments are appreciated!

NOTE: This is the V2 version - now sized better (no scaling required) and redesigned in FreeCAD