Cream Jar - Small Cosmetics

Needed a small cream jar that was easy to print w/ rounded internals; The first few times you thread the cap on, it might feel a little notchy, but after a few turns it should be silky smooth; It's from the print seams that cause it to protrude out a little.
 

Dimension are:

• 40mm x 22mm 

--------------------------------------------------------------------------------------------------------

Updated: 10/13/2025 - Same Dimensions (40 x 22mm)

• Edited the Threads for better fitment 
  • Double Start - Threads 
  • Changed the Height of the Cap and the Base to be equal; 11mm Both
  • Edited the Chamfering of the Internals; Angle Flows Better and Prints Smoother
  • Knurling on the Cap- Found the old design to be very slippery when Opening
  • Offset Increased on the Internal Threads in the Cap; Better Fitment and Smoother Turns
  • Decreased the revolutions needed to close; Went from 2 Revolutions to 0.75 (Only need a ¾ turn to Close or Open)
     
• Made a Smooth Cap Version as well w/ all the Changes Above
  • Similar Offset Dimension as the Cap w/ the Knurling; Just Smooth