February 4, 2024
Description
First layer .16mm, then .08mm for the rest, with 15% infill.
Colors used in sample 1:
Black, Transmission Distance 0.06mm
Natural or gray translucent, Transmission Distance 16mm*
Red, Transmission Distance 1.0mm
Yellow, Transmission Distance 6.5mm
White, Transmission Distance 0.5mm
Colors used in sample 2:
Black, Transmission Distance 0.06mm
Natural or gray translucent, Transmission Distance 16mm*
Blue, Transmission Distance 1.0mm
Gold Transmission Distance 4.0mm
White, Transmission Distance 0.5mm
*Anywhere from TD 10-21mm previews quite well in Hueforge in natural or gray, with higher being more subtle and lower being more bold. Just make sure it's reasonably translucent.
This print uses 5 colors, if using AMS, set the 5th color to the same slot as the first color. Swap out the black for the white after the black layers are finished.
Layer height changes:
Color 1 (black) : layer 10, 0.88mm (AMS: after the black is done, remove it and replace it with white)
Color 2 (translucent) : layer 12, 1.04mm
Color 3 (red or blue) : layer 15, 1.28mm
Color 4 (yellow or gold) : layer 23, 1.92mm
Color 5 (white) : layer 24, 2mm
The frame I used is here. I have a profile there as I found the designer's profile was prone to splitting when the pegs were inserted and the overhangs were too steep in the channel where the picture sits. https://makerworld.com/en/models/64865#profileId-188783
License:
BY-NC-SA
luciel
