Vanquish VRD Chassis Brace Crossmember

I made this model for my Vanquish VRD Carbon because I put a competitive cab only body on it and there was some space it left in the back. I haven't tested it on the stance but I would assume it fits that too. This model has a military star that I put on it to match my army green truck. I will also be making this model with a Vanquish logo, if that's what you would prefer make sure to check that out. You should be able to use the screws it came with and I added a picture of where to screw it in. There is a cutout in the bottom so it doesn't hit the links too much, on mine it touches the links right as the shocks are fully compressed and when just one side is flexing it doesn't touch at all. I used PLA and I'm sure PETG would work just as good.

70mm wide

55mm long

10mm thick

One hole is 7mm from the edge and the other hole is 35mm from that

Both holes are 5mm from the top and bottom and are 8mm deep

M3x8 screws

Boost MePlease boost so I can make more models to help you out with RC stuff