Articulated Fire Breathing Dragon

Boost Me🚀🚀Want to help a creator out? boost me!🚀🚀🎉

 

MASSIVE ARTICULATED FIRE BREATHING DRAGON!!!!!

Epic looking dragon with costomizable poses for a perfect model for the top of your desk!!

Inspired by a legendary dragon design and enhanced with a custom AI-generated fire effect, every detail has been carefully cleaned and perfected for maximum impact.

                     ✨ Features:

• Fully articulated for dynamic poses
• Stunning fire effect, crafted with AI magic
• Fireball doubles as a support, letting the dragon stand upright!
• High-detail sculpt made in Blender
• Hand-cleaned and optimized for 3D printing

silk pla gives the model a clean look, and shiny finish. the model will stand up on its own, supported by the fireball.the legs are printed inside the dragon's body giving it useful legs that also look amazing!!! the wings have a full 5 joints, and flexible funconality that will print with minimal effort.

                                                                                                                                                                                                                                                          

 

OK enough advertising….

the dragon printed on my ender 3 in over a day, and the fireball in over 12hours, with 0.16 layer height. the fireball needed quite a few supports, which I sort of bummed about at first, but after I finished printing, I realized the the supports make the fireball look even more fire-y. You may want to put supports on the mouth of the dragon, but other then that I desingned it to have only small overhangs, so that those of us with warping and curling issues can still printit without problems. I used standard silk pla settings, 15mm/s for outer walls, 40mm/s for inner walls and 70mm/s for infill. 3 bottom layers 3 top layers, fan on at layer 4, 220* nozzle and 60* on glass bed. you don't have to print it in bambu lab filament at all even though I did. its just filament. the silk pla was by Eryone.

 

I had absolutly no problems printing whatsoever, which i found suprising, to be honest…

if you have success printing it, please leave a comment down below.

again i got the idea from @IXPatch with his pokemon dragon.