Safety Razor

I wanted a lightweight razor to take with me when travelling. Not that my daily one is heavy or anything, but every ounce matters. I decided to model one for a challenge, and after many iterations, I finally came up with this. I have been using it regularly at home with no problems. 
I suggest using my 3MF file to print yours since I have added modifiers to the threaded parts so that infill is at 100%. My early ones were printed at 15% infill overall and I found the thread snapped off after a while. It was quite difficult getting just the right fit of the head over the blade so that it curved slightly, but got there in the end. 
Supports on one part of the head only, with a brim for the handle which is printed vertically. I tried printing the handle horizontally but found that the hole got distorted. And, yes, it still printed even on the A1 Mini bed-slinger (two plates because I configured Print by Object rather than By Layer).

I would recommend printing in PETG and haven't tested PLA.