Skull throwing double fingers w/ no regrets No AMS

Just a fun piece of Halloween art to hang on the wall.  This guy is way too cool.  Everyone loves him around here!  I even made one to bring into the office.  :)    There is an Eye hook located on the back for easy hanging.

Feel free to scale up or down.  Please note:  If you scale SMALLER, make sure you don't make the Z height any thinner than it is as it will effect the eye hook on the back. 

No AMS needed.  If you only have a single color 3D printer, just set up the print to pause/change filament on layer 34 in your slicer and load your desired color for the top section.   

 .16 layer height profile was used.  If you want a little faster print time but sacrifice some quality, it will print with a .20 layer height.

No supports needed for the eye hook.

Please note:  You may get an error in your slicer saying there are non manifold edges,  you can ignore this.  I test printed this 7 times.  5 printed perfectly as I'm uploading it.  The other 2 had problems when I let the slicer fix the error.  So I wouldn't suggest fixing them.