变形金刚：擎天柱 Tramsformer：Optimus Prime

使用0.2喷头，耗材拓竹PLA Basic 红 蓝 白 三色。已调好参数，可直接打印。
以100%填充的层高度为0.06mm首层高度为0.16mm

模型尺寸为144.31x250mm您可以在低于基础厚度0.46mm的更高层高度打印 
最大允许厚度厚度3.4mm和实际厚度3.4mm 

使用的耗材：
    PLA BambuLab Basic Blue 蓝 透光度值TD: 4
    PLA BambuLab Basic Jade White 白 透光度值TD: 5
    PLA BambuLab Basic Red 红 透光度值TD: 4

此打印使用3种耗材 
更换耗材丝说明：
     开始 Blue
    在层#11（0.76mm）更换到Jade White
    在层#20（1.3mm）更换到Red
    在层#31（1.96mm）更换到Jade White 直到结束。 

Using a 0.2 mm nozzle, filaments are BambuLab PLA Basic in red, blue, and white. Parameters are already tuned—ready to print.
Infill 100 %, layer height 0.06 mm, first-layer height 0.16 mm.

Model size: 144.31 × 250 mm. You may print at a layer height higher than 0.46 mm while staying below the base thickness.
Maximum allowed thickness: 3.4 mm; actual thickness: 3.4 mm.

Filaments used

• PLA BambuLab Basic Blue – translucency TD: 4
• PLA BambuLab Basic Jade White – translucency TD: 5
• PLA BambuLab Basic Red – translucency TD: 4

This print uses three filaments.
Filament-change instructions

• Start with Blue
• At layer #11 (0.76 mm) switch to Jade White
• At layer #20 (1.30 mm) switch to Red
• At layer #31 (1.96 mm) switch back to Jade White and continue to the end.