Phone holder stand

Phone holder.
This time I invite you to print a phone holder.

You'll need two colors.

Optionally, you'll need TPU to print a non-slip pad for the phone and the holder.

All parts printed with layer heights of:
0.16mm for the first layer and
0.2mm for each subsequent layer


This holder even accommodates phones with cases, up to 12mm thick.

In the center is a hole for connecting the power cable.

The connected cable has plenty of space, regardless of whether you use a straight or angled cable.

Phone Holder
 

Supports option enabled.
Brim option disabled (my choice), but it's up to you - you may prefer to print with.

TPU pads
Anti-slip pads are optional, your choice. You have this option if needed.

After printing, place them in the places shown in the pictures.

Here I use double-sided tape, only 4 small pieces:

Here, I just pressed it into place and it was ready. No tape or glue needed:

Phone holder longer version for bigger phones.

I was asked to make a version with a longer back to make the largest phones more stable. 
So I made a version with a longer back (by 2cm) and a base (by 2cm). Here it is, file added.
Also anti-slip pad is optional, your choice.

If you like it: happy printing!