Porsche 911 Turbo (993) Rotana RWB Large Model!

9/21/2025 Update: This same model is now available with NO rear bumper and exposed rear turbos! Check out Print Profile #2 that's just been loaded!

 

Boost MeBoost me to support the development of even more awesome car models! 

Porsche 911 Turbo Rotana RWB (993 Gen) - Large Scale Model! 

Continuing my Large Scale Model creations with a series of the RWB Porsche models:

 

1. Starting with this awesome 993 911 Rotana RWB Build! If you thought the smaller scale model was impressive, wait until you see how it scales up to double the size! 

 

2. This same 993 Rotana RWB Porsche is now available with No rear bumper and exposed twin turbo setup! Checkout print profile #2 that just been loaded!

 

The smaller scale Porsche models can be found in my previous upload! : https://makerworld.com/en/models/1779182-porsche-911-turbo-rwb-car-model-set#profileId-1895028

 

The other 2 RWB large models can be found here!  : https://makerworld.com/en/models/1788725-porsche-911-turbo-rwb-maverick-964-large-model#profileId-1906142

 

 

What started as a quick large-scale print experiment based on my recent smaller model car collection has quickly turned into a growing obsession of turning all of my favorite cars into large scale, better detailed, prints! This Porsche was a perfect candidate with all the awesome widebody aero work and scoops! 

 

This model is approximately 300mm (11.8 in) length x 120mm (4.72 in ) width x 80mm (3.14 in ) height: Literally double the size of the 

smaller scale! Here it is compared to the regular sized models I have been uploading recently:

 

 

Please note that you may also need to use a little glue on the wheel/tire depending on your material.

 

The print profile comes dual color CCW classics wheel set (but the SSR SP1 from the other large scale RWB model should work as well!). 

Please note that depending on some filaments, the fit from wheel to car maybe a bit on the tight or loose side. Do a quick test fit, if it's too tight, just use your knife or scraper to knock off a little material, if it's a bit loose, apply some glue. I did my best to accomodate most filaments I had to test print with and the current print profile is a happy medium for all I've tried. 

 

 

If you like this model, check out all my other small and large models I have available in this car collection!: https://makerworld.com/en/collections/7784431-car-model-display-collection