Mini city treehouse PART 7

Treehouse 7 of the series

 

It's been a while, but I've finally been able to find some time to design and draw again. I received quite a few requests to design a new treehouse. Here it is, hopefully it meets your expectations.
The middle ‘round roof’ reminds me a little of the main building at Jurassic Park. Don't you think?

This model can easily be ‘centered’ on the support with the pin. You only need a few drops of glue.

AS ALWAYS, NO SUPPORTS ARE NEEDED DURING PRINTING.

Dimensions:

• Height of the house: 5 cm / 1,97 inch
• Length of the pole: 10 cm / 3,93 inches  
• The ladders are provided and compatible with the other models.

 

Thank you very much for the boosts I received. Designing requires a lot of ‘test prints’ and these make it just that little bit easier to do.

In the meantime, my first two ‘Big Bob’ models have also been released. A further development of the flower friend. Maybe you'll like these too. 

 

 

Build your own city:

             

 

 

 

Boost MeDo you like the model? Give me a free boost. I really appreciate it. Thanks!