Hope you like dog hair! Cute Welcome sign- No AMS

Just a fun piece of wall art to hang on your wall or door.  Very clean and simple design that prints great!    A must have for dog lovers!  I used to joke and tell people I had 2 golden retrievers because there was a layer of hair that seemed to have a life of its own floating around my house that looked like my dog Calvin.  Boy I miss that pup!

There is an Eye hook located on the back for easy hanging.

Feel free to scale up or down.  Please note:  If you scale SMALLER, make sure you don't make the Z height any thinner than it is as it will effect the eye hook on the back. 

No AMS needed.  If you have an AMS, its all set to go as-is.   If you only have a single color 3D printer, just set up the print to pause/change filament on the following layers:

• Start off with your base color. (This is the tan layer in my photos) 
• pause at layer 25 in your slicer to change your filament to the 2nd layer color (This is Teal in my photos)
• pause at layer 35 in your slicer to change your filament to the 3rd layer color (This is Light Blue in my photos)
• pause at layer 44 in your slicer to change your filament to the 4th layer color (This is light tan in my photos)