Halloween pumpkin - Tealight compatible

Details:

• Hollow inside all the way through and designed with removeable top to fit a LED tealight (no flame candles!)
• Double layer inside for better light dispersion
• Sturdy enough to stand on their own
• Easy to print and assemble with thoroughly tested supports.
• Made with dovetail cut for the top to be removeable as I found that the sturdiest.
• Version with removeable top and without included.
  • Note: The one where the top can't be removed can be a little tricky to print as the inside of the top wasn't designed for that. I have printed plenty without problems though. Inside might be ugly and some small strings that you can just empty out but nothing visible from the outside when it is just standing.

Print Tips:

• 1 wall
• 0.2 mm layer
• 0% infill
• Highly recommended to print with included print profile
• Tolerances can be a bit tight but works beautifully. Try scaling model a little bigger if tolerances are too tight. Finely tuned printers can also scale it down if you want a smaller pumpkin with even tighter tolerances.

Assembly:

• Works best when model have cooled off after print.
• Place the top of the lid between the two layers of the main body with leaf on the left side and slide the lid on. See picture
• Careful as the dovetail cut can break. It still works even though one or two breaks though.

Step 1: Place lid between main body layers (remember tealight if you want that)

Step 2: Slide lid on

Step 3: Done

Check out my scary tree model or see more on my profile