Mouse Case LOGITECH G305

Boost MeHEY! If you like it, Boost Me!!!!

Logitech G305 Magnetic Case – 3D Printed

A sleek and practical case designed especially for the Logitech G305. The lid closes securely with four neodymium 6×2 mm magnets, giving it a smooth, snap-fit feel without the need for glue or tools.

⚡ Assembly tip: Make sure to place the magnets with the correct polarity. To insert them, gently press each magnet into place against a hard surface until it sits flush. Avoid using glue, pliers, or any sharp tools, as these can damage the plastic.

This case is basically a G305 holding a G305—a bigger replica of the mouse itself, like a matryoshka doll or a little bit of 3D-printed inception, you choose. It’s designed for those who want to carry their mouse safely in a bag without it getting squished or scratched.

 

**I personally like to sand the rough edges after printing for a smoother finish and a more premium feel.

 

FOR OPTIMAL RESULTS PLEASE FOLLOW THE INSTRUCTIONS BELOW:

 

For the Upper_Side

 

Support

Enable support → ✅ (enabled)

Type → tree(auto)

Threshold angle → 50°

On build plate only → ⬜ (disabled)

Support critical regions only → ⬜ (disabled)

Remove small overhangs → ⬜ (disabled)

Initial layer density → 50%

 

Seam

Seam Position→ Aligned

 

 

For the Lower_Side

 

Enable support → ✅ (enabled)

Type → tree(auto)

Threshold angle → 40°

On build plate only → ⬜ (disabled)

Support critical regions only → ⬜ (disabled)

Remove small overhangs → ⬜ (disabled)

Initial layer density → 70%

 

Seam

Seam Position→ Back

 

 

Hope you 'll like it !