Raleigh Burner BMX Model

Boost Me

Raleigh Burner BMX Model 

 

Model BMX based off a Raleigh Burner with rotating wheels, crank and pedals.  

Feedback greatly appreciated! 

Pre-assembly: 

Some parts may need sanding/filing before assembly to ensure a perfect fit. 

Tools needed:  

• Drill bit. (2mm, 4mm, 5mm & 6mm)  
• Glue. 
• Rasp/small file or sandpaper. 
• TPU (To use as brake cable) 

 

**(Drill bits to be used only by hand or pliers to prevent damage to parts)** 

2mm drill bit used for pedals brake lever brake caliper frame and fork, 4mm drill bit used for wheel hubs (if needed) and seat post, 5mm drill bit used for headset, 6mm drill bit used for bottom bracket.  

 

 

 

 

 

 

 

 

 

 

 

Assembly guide 

 

Step 1 (Wheels) 

Place the alignment pin (3 black pieces) into the correct cut outs on one half of the wheel.  

Apply glue all round and then place the second half of the wheel onto the first. 

(As shown below) 

 

(Repeat step one for other wheel) 

Step 2 (Fork & Stem) 

Slide fork through the headset on frame and attach stem to the fork with some glue. 

(As shown below) 

 

 

Step 3 (Handlebar & Stem Top) 

Place handlebar in the groove on stem, put a drop of glue in cut out on the stem then cover with stem top. 

(As shown below) 

 

Step 4 (Brake Lever & Grips) 

Slide on brake levers and grips. 

(As shown below) 

 

 

 

Step 5 (Drive Chain & Crank)  

Get the drive chain and thread it through the right side of the chain stay on the bike frame. Then glue the end of the chain to the cut out on the ring. 

 (As shown Below) 

 

Next slide the crank through the drive chain then the frame and secure on the other side with the crank cap. 

(As shown Below) 

 

 

 

 

 

Step 6 (Crank Arms & Pedals) 

Grab the crankarms and attach them on both sides of the crank via the square holes. Next slide the pedals on to the other end of crankarms. (Use a 2mm drill bit by hand to open hole on the pedals) (Apply a little heat to the end of the crankarm and flatten a touch if the pedal slides back off) 

(As shown Below) 

 

 

 

Step 7 (Gear & wheels) 

Slide gear through chain, then on to the right side of rear hub. 

(As shown Below) 

 

Next slide axle through frame and wheel hub then secure on the other side with axle cap. 

Repeat axle on front wheel. 

(As shown Below) 

 

 

STEP 8 (Seat & Brake Calipers) 

Glue the two halves of the Seat together, then push seat clamp on to frame. Slide seat into frame.  

 (As shown Below) 

 

 

 

 

 

 

 

 

 

Next push caliper through holes on frame and fork. 

 (As shown Below) 

 

STEP 9 (Crash Pads& TPU Cable) 

Apply glue to one side of pad then place over frame and bars. 

(As shown Below) 

 

 

Finally cut some TPU to size and glue it in holes on calipers levers and frame crash pad . 

(As shown Below) 

 

 

Enjoy.