Gen 2 Now Live!
Gen 2 Improvements include:
- Material savings
- Bottom cut out for easy lubrication
- Larger gear ratio for better dispensing (change of big and mid gear teeth counts)
- Elimination of mid gear axle hole on the side of the case
- Mid gear mounting is updated to use the new gear plate
Description
The SKPOP Card Dispenser Original is designed as a k-pop photocard vending machine. The dispenser reliably dispenses 1 card at a time with the flip of a lever. Use it as your own “lucky draw” machine, or simply a playing card dispenser!
- Higher capacity, larger card size compatibility when compared with Dispenser Mini
- Works for cards up to 90mm in length and up to 78mm in width
- Fits up to ~70 cards
- Adjustable to work with sleeved/unsleeved cards of various thicknesses
- Note: the handle one-way clutch tolerance is calibrated to X1C. A reduced tolerance version is available if your handle gets stuck. See attached step file.
Tips and commercial license: https://ko-fi.com/skpop
Measurements
📐 Overall Dimensions: 156 mm Height * 143 mm Depth * 120 mm Width
📏 Card tray internal dimensions: 78 mm Width * 95 mm Length
Components Required
You will need the following non-printed components:
- 8x M3 screws, length between 6 and 12 mm (Alternatively, use superglue)
- 1x rubber strip, length = 115 mm (for 36mm diameter roller drum), width ~ 15 mm, thickness ~ 2 mm;
Example: https://a.co/d/czWigbg (Alternatively, use rubber band) - Optional: 2x 5x2mm magnets
Assembly Instructions
Link to Gen-2 instructions with images: https://sakupop.notion.site/Gen-2-Photocard-Dispenser-Assembly-Instructions-34adb1b58633800292d3f9ec5dd73f22?
- Insert big gear [08] through the gear plate [10], then through the case. Make sure the gear plate sits between the two notches on the inside of the case.
- Slide mid gear [07] onto the gear plate.
- Install Handle [11] onto the gear axle from the outside of the case, then secure with a M3 screw.
- Insert roller gear [06] through roller gear mount [05] into roller drum [04], then secure with a M3 screw. Wrap the roller drum with rubber strip.
- Install the roller assembly to the bottom of the card tray [03], then secure with 2x M3 screws.
- Snap front roller [09] into card tray [03]. The front roller should not rotate freely. Make sure the two notches are pointing up.
- Install the card tray assembly into case [01] - be careful not to push the gear plate out of position. Secure with 3x M3 screws. (Note: there are extra holes in case threads are stripped)
- Install lid [02] and dispense!
- Optionally, use the two card clips to hold a display card, and hang them on the case.
Adjustment for different card types
- To use with unsleeved cards, or if multiple cards come out at once, adjust by rotating the front roller [6] forward 90° so that the notches point sideways. This decreases the dispensing gap to accommodate thinner cards. Rotate more (up to 180°) if needed.
- Rotating the front roller backwards will tighten the dispensing gap (if you found yourself dispensing multiple cards at once)
Please consider supporting me by liking and boosting!
Archive
OUTDATED: Gen 1 Assembly Instructions (Please see .zip file for Gen-1 models)
https://sakupop.notion.site/Original-Photocard-Dispenser-Assembly-Instructions-28bdb1b586338041a186f3dac7aff267?
sakupop
