Headphone Stand - Industrial

[Introduction]

A headphone stand with industrial styling!

I have my previously designed stand, but it's not always suited for larger headphones. I also wanted something a little more industrial styled, and thus managed to come up with this.

Model is featured in Bambu PLA Matte Charcoal and Bambu Iridium Gold Metallic. A good alternative with similar look to Bambu's metallic is Hatchbox's Metallic line. There might be others, but that's the one I'm aware of.

[Spotlight]

Check out this PS5 Headset focused remix by Johan Jamaer - JJ Deluxe Designs! 

[Tools & Hardware]

(Full disclosure, I am part of the Amazon Affiliate Program. All amazon links are affiliate links. I earn a small commission from these links without any added cost to you. These links help to support me so I can bring more content for free!

This project uses M4 Machine screws. As of the writing of this, Bambu's Makerlab doesn't supply suitable M4 screws, so you'll have to look to Amazon, or the such. I'd recommend an assortment like this Amazon US)

Hardware

• 2x M4x10mm 
• 4x M4x16mm
• 4x M4x20mm
• 4x M4x25mm 
• 4x M4x40mm
• 16x M4 Nuts 

Tools

• Hex Driver
• Drill bit for clearing holes

[Assembly]

Start by clearing out the holes as illustrated. A flat surface was left on these holes so additional support wouldn't be needed during printing. Only the leg and foot pads will need this.

For assembly, you'll be using the 3d printed spacers along with the M4 screws. The side with the nut is wedged slightly, so as you tighten it, it should grip onto the model instead of spinning.

For the headphone rest, first screw the top to the bracket.

Then use the following image to help guide the rest of the build, and which screws go where. First assemble the main arm, and then work your way outwards, attaching the base, legs, feet, and headphone rest.