Bracket for AMS Hub - A1 series

A bracket for the new AMS hub/buffer that lets you use AMS, AMS2 Pro and AMS HT with the A1 series.

 

The one BambuLab use in the wiki page is mounted on the gantry and that can potentially lead to problems with the cables moving up and down.

This bracket can be mounted on the back of the A1 or A1mini frame using the screw holes for the transport/stiffener/spool holder bracket.

It is angled so the cable connections are pointing to the rear for better cable management and will not interfere with the print bed.

 

For mounting you can use the screws that came with the transport/spool holder bracket or any M3x8mm.

 

NOTE: Older A1's may not have all the mounting holes on the back of the frame.

 

Updates:

Made a PTFE tube guide for the hub. See link below.

Added a A1 Left side version for anyone who wants to place the AMS to the left of the printer and keep tubes short.

Added a version 3 with holes for all positions: A1 lower and upper holes + A1mini. (Some A1's do not have the upper holes)

Made a version 2 with a tighter slot and some minor design improvements. 

 

Please write in the comments if there are any issues with fitment or suggestions.

 

I made a PTFE tube guide that snap on the top of the hub to help with squeaking and feeding problems:

https://makerworld.com/en/models/2650530-ptfe-tube-guide-for-a1-series-ams-hub-no-squeak

 

I also made a bracket to use the old P1/X1 buffer on A1 and A1mini:

https://makerworld.com/en/models/1912252-ams-buffer-bracket-for-a1-and-a1mini#profileId-2050731

 

Hub top mount for the A1mini:

https://makerworld.com/en/models/1909171-top-mount-bracket-for-ams-hub-a1-series#profileId-2047108

 

Boost Me